Britax FRONTIER Guia Del Usuario página 9

Installing the Child Seat: Harness Mode
Lower Anchors with CLICKTIGHT
Before you begin:
• Check that your vehicle has lower anchors.
* Use the vehicle belt (not lower connectors) for harness
mode installations with children who weigh more than
40 lbs (18.1 kg).
• Check that your vehicle has a top tether anchor.
* The top tether MUST be used in harness mode for
children that weigh more than 65 lbs (29.5 kg). BRITAX
recommends that the top tether be used at all times
when installing the child seat. Using the top tether will
improve the stability of your child seat and reduce the
risk of injury. Check your vehicle owner's manual for
tether anchor locations.
• Loosen the tether and place it over the child seat back to
keep it from becoming pinned between the child seat and
vehicle seat during installation.
• Adjust the child seat to desired position and place forward
facing on the vehicle seat.
Release the buckle and open
1
the CLICKTIGHT to access the
lower connectors.
* Locate the two slots in the
CLICKTIGHT cover.
* Squeeze the CLICKTIGHT
release levers.
12
Installing the Child Seat: Harness Mode
Route the lower connector
2
strap along the green belt path
and firmly press the lower
connectors onto their adjacent
lower anchors.
* A click confirms attachment.
* Verify that the strap is not
twisted.
Pull the end of the lower
3
connector strap to remove
slack.
IMPORTANT: Only remove slack
from the lower connector webbing.
Overtightening the webbing may
prevent the CLICKTIGHT from
properly securing.
Close the CLICKTIGHT.
4
* A click confirms the
CLICKTIGHT is secure.
* The child seat is secure when
it cannot be moved front-to-
back or side-to-side more
than 1 in. (2.5 cm) at the belt
path. If the child seat is not
secure, repeat the installation
procedure or use a different
seating location.
Firmly press the tether hook
5
over a designated vehicle
tether anchor. Remove slack.
Secure excess webbing with
6
the elastic strap.
Checklist
9 Check all connections and verify that child seat is secure.
* The child seat is secure when it cannot be moved front-to-
back or side-to-side more than 1 in. (2.5 cm) at the belt path.
If the child seat is not secure, repeat the installation procedure
or use a different seating location.
9 Check that any excess tether webbing is contained within
your vehicle and secured in the elastic strap.
OR
OR
13