General Regulation Of Use; Unit Protection; Noise Emission - LORCH M-Pro BasicPlus Serie Manual De Instrucciones

Tabla de contenido

Idiomas disponibles

Keep a fire extinguisher near the

welding area.

Check the welding area for fire af-

ter welding (see UVV*).

Never try to disassemble the pres-

sure reducer. Replace the defecti-

ve one.

The machine must be transported

or set up only on firm, level surfaces.

The maximum admissible angle of

inclination for setting up or trans-

porting is 10°.

Service and repair work may only be ca-

‰

rried out by a trained electrician.

Ensure that the ground cable has good

‰

and direct contact near the welding loca-

tion. Do not allow welding current to pass

through chains, ball bearings, steel cables

or grounding equipment; this may melt

them.

Secure yourself and the welding machine

‰

when working in elevated or inclined areas.

The machine may only be connected to a

‰

properly grounded mains supply. (Three-

phase four-wire system with grounded

neutral conductor or single phase-three-

wire system with grounded neutral con-

ductor) socket and extension cable must

have a functional protective conductor.

Wear correct protective clothing, leather

‰

gloves and leather apron.

Protect the welding area with curtains or

‰

mobile screens.

Do not use this machine to thaw frozen

‰

water pipes or cables.

In closed containers, under cramped con-

‰

ditions, and in high electrical risk areas,

only use machines with the S sign.

Switch off the machine during breaks and

‰

close the valve of the gas cylinder.

Secure the gas cylinder with a chain to

‰

prevent it falling over.

- 32 -

Disconnect the mains plug from the mains

‰

before changing the place of installation

or making repairs to the machine.

Please heed the safety regulations which

apply to your country. Subject to change.