Filter Clean Reminder Setting - Airwell DED076 Manual De Usuario

Energy Saving Function: Energy saving can make the air conditioner run at a
smaller temperature range by setting lower limited value of setting temperature in
cooling or dry mode and upper limited value in heating mode.
Energy saving setting for heating
When the unit is on and in heating mode, press the Function button until reaching
energy saving function, with
energy saving function for heating and then press or button to adjust upper
limited value of the set temperature in heating mode. After that, press the
Enter/Cancel button to turn on energy saving function for heating.
After the energy saving function is on, press the Function button to reach the
energy saving function and press Enter/Cancel to turn off this function.
The energy saving setting is shown in the fig.15：
Save Setting for Heating: When unit is on and under Heating, 3D Heating and
Space Heating modes, press FUNCTION button to select Save function. "
blink and MAX icon lit up. Press "
temperature. Press ENTER/CANCEL button to turn on this function.
Turn off Save Function: Press FUNCTION button and select Save function. "
icon blinks. Then press ENTER/CANCEL button to cancel this setting.
Note: When the Save function is turned on and then set temperature exceeds the
limit value for Save function, "
two sounds successively.

4.12 FILTER CLEAN REMINDER SETTING

Filter Clean Reminder Function: Unit will remember its own operating time. When
the setting time is up, this function will remind you to clean the filer. A dirty filter will
result in bad heating and cooling performance, abnormal protection, bacteria gathering,
etc.
Turn on Filter Clean Reminder Function: When unit is on, press FUNCTION button
and select Filter Clean Reminder. "
adjust the cleaning level, of which the range is 00, 10-39. Press ENTER/CANCEL to
turn on this function
blinking. Press the Mode button until reaching
" or " " or " " " button to adjust the MAXIMUM
" icon blinks three times and then buzzer will give out
" icon will blink. Press "
26
User Manual Wired Controller
" or " " button to
" icon will
"