How To Set The Unit; Power On Display; Main Function - TECshow RAZOR 7R BEAM Manual De Usuario

6. How to Set the Unit

6.1 Power On Display

Every time you turn on the unit, it will run built-in program to
reset all motors to their home position, the display will show
as fig.4, you may hear some noises for about 20 seconds. It
will show warning sign if it goes wrong during resetting and
you can press the MENU button to view the error information.
After that the unit will be ready to receive DMX signal and the
display will show as fig.5.
Explanation of fig.5:
Base 40°C Show temperature of base CPU is 40°C
001 Show start address
Md.1 15. Show channel mode is mode 1 (15 channels mode)

6.2 Main Function

Turn on the unit, press MENU button into menu mode, press
UP and DOWN button until the required function is shown on
the monitor. Select the function by ENTER button. Use UP
and DOWN button to choose the submenu, press the ENTER
button to store and automatically return to the last menu.
Press MENU button or let the unit idle one minute to exit
menu mode.
In the event of disconnecting with mains power, press UP
button for one minute to enter into menu mode. Press MENU
button or let the unit idle one minute to exit.
The main functions are shown below(the grayed boxes are
preset settings):
RAZOR 7R BEAM
ENGLISH VERSION
Fig. 4
p. 9