Address Setting; Dmx 512 Configuration - TECshow RAZOR 7R BEAM Manual De Usuario

7.3 Address Setting

If you use a universal DMX controller to control the units, you
have to set DMX address from 1 to 512 so that the units can
receive DMX signal.
Press MENU button to enter menu mode, select DMX Func-
tions, press ENTER button to onfirm, use UP and DOWN but-
ton to select DMX Address, press ENTER button to confirm,
the present address will blink on the display, use UP and
DOWN button to adjust the address from 0 to 512, press
ENTER button to store. Press MENU button back to the last
menu or let the unit idle one minute to exit menu mode.
Please refer to the following diagram to address your DMX512
channel for the first 4 units:
Channel mode Unit 1 Address Unit 2 Address Unit 3 Address Unit 4 Address
15 channels
14 channels
18 channels

7.4 DMX 512 Configuration

Please refer to below configurations to control the fixtures
Attention:
1. The unit will maintain the last condition until reset if you
cut-off the DMX signal.
2. For the channel Function, keep the value for about 5 sec-
onds, then the corresponding function will take into effect.
RAZOR 7R BEAM
ENGLISH VERSION
1 16
1 15
1 19
31 46
29 43
37 55
p. 18