Safety Instruction - TECshow RAZOR 7R BEAM Manual De Usuario

1. Safety Instruction

Please read carefully the instruction manual, which includes important information about the installation, usage and maintenance.
Please keep this User Guide for future consultation. If you sell
the unit to another user, be sure that they also receive this
instruction manual.
Important: Damages caused by the disregard of this user
manual are not subject to warranty. The dealer will not
accept liability for any resulting defects or problems.
• Unpack and check carefully that there is no transporta-
tion damage before using the unit.
• The unit is for indoor use only. Use only in a dry location.
• Do install and operate by qualified operator.
• DO NOT allow children to operate the fixture.
• Use safety chain when fixing the unit. Handle the unit by
carrying its base instead of head only.
• The unit must be installed in a location with adequate
ventilation, at least 50cm from adjacent surfaces.
• Be sure that no ventilation slots are blocked; otherwise
the unit will be overheated.
• Before operating, ensure that the voltage and frequency of
power supply matches the power requirements of the unit.
• It's important to ground the yellow/green conductor to
earth in order to avoid electric shock.
• Maximum ambient temperature TA: 40°C. DO NOT oper-
ate it when the temperature is higher.
• DO NOT connect the device to any dimmer pack.
• During initial start-up some smoke or smell may arise.
This is a normal process and does not necessarily mean
that the device is defective, and it will decrease gradually
within 15 minutes.
• Make sure there are no flammable materials close to the
unit while operating to avoid fire hazard.
• Examine the power wires carefully; replace them imme-
diately if there is any damage.
• Unit's surface temperature may reach up to 85°C. DO NOT
touch the housing 2A bare-handed during its operation,
and allow about 15 minutes for cooling the unit down
before replacing bulb or maintenance as it could be very hot.
• Avoid any inflammable liquids, water or metal objects
entering the unit. Once it happens, cut off the mains
power immediately.
• DO NOT operate in dirty or dusty environment; do clean
the fixture regularly.
• DO NOT touch any wire during operation as there might
be a hazard of electric shock.
RAZOR 7R BEAM
ENGLISH VERSION
• Avoid power wires twist other cables.
• The minimum distance between light output and the il-
luminated surface must be more than 12 meters.
• Disconnect mains power before fuse/lamp replacement
or servicing.
• Replace fuse/lamp only with the same type.
• In the event of serious operating problem, stop using the
unit immediately.
• Never turn on and off the unit time after time.
• The housing, the lenses, or the ultraviolet filter must be
replaced if they are visibly damaged.
• DO NOT open the unit as there are no user serviceable
parts inside.
• Never try to repair the unit by yourself. Repairs carried
out by unskilled people can lead to damage or malfunc-
tion. Please contact the nearest authorized technical as-
sistance center if needed.
• Disconnect the mains power if the fixture is has not been
used for a long time.
• Do use the original packing materials before transport-
ing it once again.
• To prevent or reduce the risk of electrical shock or fire,
do not expose the unit to rain or moisture.
• Hot lamp explosion hazard. Do not open the unit within
15 minutes after switching off.
• Do replace the bulb once it is damaged, deformed or
life-expired.
• DO NOT look directly at the light while the bulb is on.
• Never touch bulb with bare fingers, as it is very hot
after using.
• DO NOT start on the unit without bulb enclosure or when
housing is damaged.
NOTICE: We strongly suggest that you use Philips Plati-
num 5R lamp and drive, or we will not be responsible if
there is any quality problem.
p. 3