Scan Function - Promax -27 Manual De Uso

USER'S MANUAL. PROMAX-27
MODEM [F3]:
SCAN [F4]:
START [F5]:
NOTE:
Access to the function SCAN / SPECTRUM switches depending on the type of
tuning you are doing.
In case you are tuning a signal using frequency, it will be displayed the
SPECTRUM function first.
In case you are tuning a signal using the predefined channels from the channel
plan, it will be displayed the SCAN function first.
4.2.3.3

SCAN function

To access the SCAN function
1.- Press key
2.- Press softkey MODEM [F1].
3.- Press softkey SPECTRUM / SCAN [F3].
4.- Press softkey SCAN [F4] (if coming from SPECTRUM screen).
The SCAN function shows numerically the level of the channel where the cursor,
which is at the top of the screen, is pointing (Figure 12.-).
09/2010
Returns to the MODEM screen (refer to section 4.2.3).
Returns to the SCAN screen (refer to section 4.2.3.3).
Starts searching for channels.
[13].
Figure 12.- SCAN function.
Page 27