CMT ORANGE TOOLS CMT900 Manual De Instrucciones página 18

AA DRILLING FOR HINGES
Drilling holes in the body (NK hinge fitted)
Insert two metal pins (pos. 2) in 57 holes (Fig. 15). Position the CMT900 on the work piece so that
the central axis of the chosen hinge spacing on the template is aligned with the central axis on the
work piece and the pins are up against the front edge of the work piece. Use the CMT400-1 adaptor
chuck with a drill bit for Ø3mm blind holes for wood screws or Ø5mm for euro screws.
A
2
A
Fig. 15
Make certain that the stops are up against the front edge of the board and the hinge axis on the
drilling template is at the same place as the hinge axis on the work piece. Fix the drilling template
to the work piece using clamps. Set the drilling depth of the adaptor chuck according to the wood
screws used. Insert the adaptor chuck with the relative drill bit in the main row of holes and drill a
hole to the right of the axis and another to the left of the axis (detail Fig. 15). Make certain the drill
rotates in the correct direction – these are right-hand bits.
www.cmtorangetools.com
18