Blank Positioning - Amann Girrbach ceramill motion 2 Instrucciones De Uso

4.3

Blank positioning

The Ceramill blank holder for rotational milling
has a mounting pin [4], onto which the Ceramill Ti
form blank [8] is mounted by means of its connec-
tion geometry [6].
1
9
Fig. 17 Components for blank placement
1 Ceramill blank holder for rotational milling
2 Blank screw (already factory-mounted)
3 Face surface
4 Mounting pin
5 Blank nut (already factory-mounted)
6 Connection geometry on machine side
7 Millable part of blank
8 Ceramill Ti form blank
9 Labelling
NOTE:
The blank screw [2] and the blank nut [5] can be
unscrewed and removed from the hole of the
mounting pin.
▷ When reassembling, insert the blank screw [2]
into the side of the pin with the labelling [9] of
the blank holder 4. This ensures that the
Ceramill Ti form blank is correctly mounted
(mechanical coding).
P R O C E S S I N G C E R A M I L L T I F O R M B L A N K S
2
3
5 8
4 6 7
D1
A1 A2
Fig. 18 Views of the Ceramill Ti form blank
A1 Rear side of the blank!
A2 Bottom side of the blank!
A3 Front side of the blank!
D1 Recess for blank nut
D2 Recess for blank screw
The Ceramill Ti form blank has holes [D1] [D2] both
on the front side [A3] as well as on the rear side
[A1]. The diameter of hole [D2] is smaller than that
of hole [D1]. When mounting the connection geom-
etry [6] of the blank [8] to the mounting pin [4],
the rear hole [D1] accepts the blank nut [5] and
hole [D2] accepts the blank screw [2]. This
ensures that the Ceramill Ti form blank cannot be
mounted incorrectly, turned by 180°.
The mounting pin [4] and the face surface
[3] of the Ceramill blank holder for rota-
tional milling must be absolutely clean.
▷ For placement of the Ceramill Ti form blank:
Loosen the blank screw [2] on the mounting pin
[4] of the Ceramill blank holder for rotational
milling.
To mount the blank [8] onto the mounting
pin [4], it is not necessary to unscrew the
blank screw [2] completely.
D2
A3
E N
29