Livestrong LS8.0E Manual Del Propietário página 15

ASSEMBLY STEp 3
lS10.0E SHOWN
CONSOLE MAST
CONSOLE CABLE
PRE-INSTALLED BOLTS
& WASHERS
MAIN FRAME
NOTE: Be
careful not
to pinch any
wires while
attaching the
console mast.
GUIDE RAIL
PEDAL ARM WHEEL
CRANK
PEDAL ARM
WAVY WASHER (L)
FLAT WASHER (K)
SPRING WASHER (B)
BOLT (M)
HARdWARE bAG 3 CONTENTS :
WAVY WASHER (L) BOLT (M)
22.5 mm 20 mm
Qty: 2 Qty: 2
Open hardware bag 3.
A
Carefully pull the console cable through
B
the console mast using the twist tie located
inside the console mast.
Attach console mast to main frame
C
using pre-installed bolts and
washers.
Slide wavy washer (l) over cranK
D
followed by pedal arm as shown. Rest
pedal arm wheel on guide rail.
Attach the pedal arm to the cranK using 1
E
flat washer (K), 1 spring washer (b)
and 1 bolt (m).
Repeat steps D–E on the opposite side of the
F
elliptical.
SPRING WASHER (B) FLAT WASHER (K)
15 mm 20 mm
Qty: 2 Qty: 2
All
MOdElS
15