Publicidad
5
INSTALL THE MOUNTING BLOCKS.
Align the mounting block
from the LockNLoad platform
with the bracket. Then thread
two M6 x 16mm capscrews
from the platform hardware
and tighten to 3.5 Nm using
the torque wrench. NOTE:
The mounting block assembly
will still have movement after
tightening the screws.
6
OPEN THE COVERS.
Open the SkyLine covers.
ATTACH TOWER AND MOUNTING
7
BLOCK ASSEMBLIES TO LANDING PADS.
First lay a towel over the roof to protect it. Place the SkyLine tower and mounting
block assemblies onto your Landing Pads as shown. Be sure the SkyLine towers are
fully seated and then close the SkyLine covers. Note: The second pair of mounting
block assemblies are for reference only. Additional adapters sold separately.
Continue with your LockNLoad Platform instructions to complete your Platform installation.
Instruction #1036004A - Page 5 of 9
3.5 Nm
2X
2X
Publicidad
