After recharging for more than 4/5
hours, the charge indication LED is still
red
(note: it is very important to recharge
the
battery
according
instructions to avoid damaging the
equipment).
LCD display:
The speed is not displayed on the LCD
monitor.
Solving charger-related issues:
•
Red light does not work when charging: check that the connectors are properly connected.
Check if the normal voltage went right away, if so, please check the charger repair. If the above
is correct, the battery is likely faulty.
•
The red light does not turn green: turn off the power, after 5 seconds connect the mains
supply, it can continue to charge. The battery no longer charges, the battery is likely faulty.
•
The red light turns immediately green: check that the battery is fully charged. If it is not, the
battery or charger is faulty.
•
If the fuse has blown: do not disassemble the charger, but take it to a qualified repairer who
will replace the fuse with a new one with the same characteristics (T3.15A / 250V).
1) the ambient temperature is 40°C or
higher
2) the ambient temperature is 0 ° C or
less
to
the
3) The bicycle was not recharged after
use which exacerbated the decrease in
charge
4) The output voltage is too low to
recharge the battery.
The magnetic ball on the wheel radius
is too far from the sensor (attached to
the rear of the frame or the front fork)
which prevents the sensor from
receiving the signal when the wheel
rotates.
If the previous solutions don't work
contact your dealer or a qualified
professional.
1)
temperature below 40°C and in
accordance with the instructions
2) recharge the battery indoors and in
accordance with the instructions
3) correctly maintain the battery to
avoid an exacerbating the decrease in
charge
4) Do not recharge with a voltage
lower than 100 V.
If the previous solutions don't work
contact your dealer or a qualified
professional.
Check the distance between the
magnetic ball and the sensor and make
sure it does not exceed 5 mm.
66
recharge
the
battery
at
a