Erasing The Results - Chauvin Arnoux C.A 6121 Manual De Instrucciones

Machine number on the right starts flashing.
Select end machine number.
,
Exit selection mode.
Impression de tous les résultats enregistrés sous les numéros de machine compris entre celui de départ et celui
de fin que vous avez sélectionnés. Un symbole
l'impression. Le menu principal s'affiche lorsque l'impression est terminée.
Print all :
Press the START key to print all the saved results. A symbol
The main menu is displayed when the printout has finished.
Print automatic :
This function is used when you want to print each result as soon as the measurement has finished. Press the PRINT/RS key to
open the main menu and continue to carry out measurements. From then on the results will be printed automatically.
RS 232 :
Use the communication software of the PC to communicate with the PC.
Pressing the PRINT/RS exits the RS 232 mode and opens the main menu.
Communication with the PC is then not possible.
NOTES : Check the RS 232 format in chapter 3.6.

5.5 ERASING THE RESULTS

To erase all or part of the saved results, the CLR function must be used. There are two erase modes:
Erase all the save locations
Erase the results saved under a particular machine number
How to erase a part of the results saved ?
Enter memory operation mode.
Two modes are offered : CLEAR ALL and CLEAR MACH.
Select CLEAR ALL mode.
Confirm erase by pressing the CLR key; the ∗ symbol is displayed during erasure, then the main menu opens.
A press on
How to erase a part of the results saved ?
Enter memory operation mode.
Two modes are offered : CLEAR ALL and CLEAR MACH.
Select the CLEAR MACH mode, the machine number to erase is displayed.
Press the MACH ñ key to select the number of your choice.
Confirm erase by pressing the CLR key; the ∗ symbol is displayed during erasure, then the main menu opens.
A press on
before confirming the erase operation (CLR) allows you to exit without erasing.
before confirming the erase operation (CLR) allows you to exit without erasing.
∗
clignote à côté du curseur du côté gauche de l'écran pendant
∗
flashes next to the cursor on the left of the screen during the printout.
43