Kyosho Mini-Z Racer Manual De Instrucciones página 39

TROUBLE SHOOTING /
Problem
Model doesn't move
Loss of Control
Doesn't Run Straight
Doesn't Stop
Running Too Slowly
Cause
Transmitter or chassis power switch is
not ON.
Polarity or battery type is wrong.
Batteries have run down.
Batteries have run down.
Antenna is missing or not attached
properly.
R/C model using same band (frequency)
is nearby.
Main road or large steel pylon is nearby.
Front Wheels vibrate side to side.
Steering Trim is not adjusted correctly.
Front and Rear Wheel Nuts are too tight.
Throttle Trim is not adjusted correctly.
Batteries have run down.
Motor has lost power.
Front and Rear Wheel Nuts are too tight.
Dust or foreign objects are inside gears.
39
Correction
Switch power on as per Instruction
Manual P.16.
Check polarity and type as per Instruction
Manual P.13,P.15.
Change batteries as per Instruction
Manual P.20.
Change batteries as per Instruction
Manual P.20.
Attach Antenna and as per Instruction
Manual P.13,14 and extend transmitter antenna.
Run model in different area, or change
the crystal (P.23) for a different band.
Run model in different area.
Due to high performance digital servo some
vibration may occur. This is not a fault
Make adjustment as per Instruction
Manual P.18.
Tighten Wheel Nuts as per Instruction
Manual P.23.
Make adjustment as per Instruction
Manual P.16.
Change batteries as per Instruction
Manual P.20.
Change to spare motor as per Instruction
Manual P.26~P29.
Tighten Wheel Nuts as per Instruction
Manual P.23.
Turn the power switch OFF and clean out
Gears.