Installation Without Base - Joie i-Gemm Manual De Instrucciones

Installation without base

!
DO NOT install this infant carrier
module on vehicle seats with Lap
Belts.
33
!
This infant carrier module is
suitable for vehicle seats with a
3-point Retractor Safety Belt only.
34
1. Place the infant carrier module
onto the vehicle seat where you
wish to put it. Pull the vehicle
safety belt out and lock it into the
vehicle buckle, sliding the vehicle
lap belt into the side guides of the
infant carrier module.
35
!
The infant carrier module can not
be used if the vehicle safety belt
buckle (female buckle end) is too
long to anchor the infant carrier
module securely. -1
35
17
33
34
35
!
!
1
2. Slide diagonal belt into the rear
guide.
36
3. Pull the vehicle shoulder belt to
fasten the infant carrier module
tightly and securely.
37
4. Level line on infant carrier module
must be level to the ground when
the infant carrier module is
installed.
38
36
!
37
38
18