Saturation Display; Lighting; Audible Signal; Cleaning And Maintenance - Gaggenau AW250191 Instrucciones De Uso

Saturation display

When the metal grease filters are saturated, a signal
sounds for approx. 4 seconds after the fan is switched
œ
off. The saturation indicator also lights up.
▯
If you have not yet done so, the metal grease filters
should be cleaned now. For instructions on how to
clean the metal grease filters, please refer to the
section

Cleaning and maintenance

▯
While the saturation indicator is lit up, it can be
reset. To do this, press the

Lighting

The lighting can be switched on and off independently
of the ventilation.
@
Press the button.
Setting the brightness
@
Press and hold the button until the desired
brightness is reached.

Audible signal

Switching on the acoustic signal
When the fan is switched off, press the
same time for approx. 3 seconds. A signal sounds as an
acknowledgement.
Switching off the acoustic signal
Repeat the "Switching on the acoustic signal" process.
Cleaning and maintenance
m
Risk of burns!
The appliance will become hot during operation,
especially near the bulbs. Allow the appliance to cool
down before cleaning.
m
Risk of electric shock!
Penetrating moisture may result in an electric shock.
Clean the appliance using a damp cloth only. Before
cleaning, pull out the mains plug or switch off the circuit
breaker in the fuse box.
m
Risk of electric shock!
Do not use any high-pressure cleaners or steam
cleaners, which can result in an electric shock.
m
Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.
20
.
œ
button.
# Ž
and at the
Cleaning agents
Observe the information in the table to ensure that the
different surfaces are not damaged by using the wrong
type of cleaning agent. Do not use
▯
harsh or abrasive cleaning agents,
▯
cleaning agents with a high concentration of
alcohol,
▯
hard scouring pads or sponges,
▯
high-pressure cleaners or steam cleaners.
Wash new sponge cloths thoroughly before use.
Follow all instructions and warnings included with the
cleaning agents.
Area Cleaning agents
Stainless steel Hot soapy water:
Clean with a dish cloth and dry with a
soft cloth.
Clean stainless steel surfaces in the
direction of the grain only.
Special stainless steel cleaning prod-
ucts are available from our after-sales
service or from specialist retailers.
Apply a very thin layer of the cleaning
product with a soft cloth.
Painted surfaces Hot soapy water:
Clean using a damp dish cloth and dry
with a soft cloth/towel.
Do not use any stainless steel cleaners.
Aluminium and plas- Glass cleaner:
tic Clean with a soft cloth.
Glass Glass cleaner:
Clean with a soft cloth. Do not use a
glass scraper.
Operating controls Hot soapy water:
Clean using a damp dish cloth and dry
with a soft cloth.
Risk of damage to the electronics from
penetrating moisture. Never clean oper-
ator controls with a wet cloth.
Do not use any stainless steel cleaners.
Cleaning the metal mesh grease
filters
These instructions apply to several appliance variants. It
is possible that individual features are described which
do not apply to your appliance.
m
Risk of fire!
Grease deposits in the grease filter may catch fire.
Clean the grease filter at least every 2 months.
Never operate the appliance without the grease filter.