Kulzer cara Scan 4.0 Guia De Inicio Rapido página 36

cara Scan 4.0 Quick Start Guide
14
3. Close the front door.
4. Double click on the cara Scan icon in the desktop
5. Click the blue arrow button "Scan"
"Basic Mode" dialog box appears.
6. Keep all the parameters by default.
7. Click on the "Scan" button to start the acquisition process. After the first 3 positions
will have been acquired, some points should be visible in the working area.
8. When the "Finalize" button
into a mesh.
NOTE
·
The scanning process can be interrupted in any moment by clicking the red square
button "Stop"
discharged. Use a Reset Axes command to restore the right plate position.
·
If the system do not perform the acquisition process correctly, see the paragraph
"Troubleshooting, Error and Causes".
·
As soon as scanning cycle has been started, the front door needs to stay closed all the
time. In case door needs to be opened scanning process will be stopped and all data
will be lost.
becomes active, click on it to transform the points
, the scanner stops immediately to work and all the data will be
.
in the top left corner of the monitor. The
W19641_REF_66069511_13_QSG_02GB_caraScan4.0_V02
© 2018 Kulzer GmbH