Ottobock 2R40 Serie Instrucciones De Uso página 14

5.3 Installation in the modular prosthesis
Recommended tools and materials:
>
710D4 torque wrench, 636K13 Loctite®
1) Connect the connecting component to the tube adapter as described in
the connecting component's instructions for use.
2) Position the pyramid receiver of the tube adapter distally in the prosthes­
is.
3) Align the clamping slot of one tube clamp adapter:
Tube clamp adapter: anterior
Tube clamp adapter, sliding: anterior or medial
Connecting the pyramid adapter and pyramid receiver
The pyramid adapter is fixed with the set screws of the pyramid receiver.
Required tools and materials:
>
710D4 torque wrench, 636K13 Loctite®
1) For definitive mounting:
Use Loctite® to secure the set screws.
2) Screw in the set screws.
3) Use the torque wrench to tighten the set screws (2R41=1: 9 Nm,
2R41=2, 2R48: 7 Nm).
Alignment
The set screws in the pyramid receiver can be used to make static adjust­
ments during alignment, trial fittings and after the prosthesis is finished.
Replacement and disassembly
The set position of the prosthetic component can be maintained during
replacement or disassembly. In order to do this, unscrew the two set screws
that are screwed in the furthest and located next to each other.
6 Cleaning
1) Clean the product with a damp, soft cloth.
2) Dry the product with a soft cloth.
3) Allow to air dry in order to remove residual moisture.
7 Maintenance
► The prosthetic components should be inspected after the first 30 days of
use.
► Inspect the entire prosthesis for wear during normal consultations.
► Conduct annual safety inspections.
14 | Ottobock