Attaching The Head Strap - Interacoustics Virtual SVV Manual De Instrucciones

Virtual SVV™ Instructions for Use – EN Page 13
Step 3
Press the face cushion to the virtual reality goggle, beginning in the center (see Figure 3.3) and working
towards the outer edges. Ensure that the entire interface between face cushion and virtual reality goggle is
bonded. This is necessary to occlude any light sources from the surroundings while the virtual reality goggle
is worn. The finished product is shown in Figure 3-8.
Figure 3-8 Correctly attached face cushion
3.6.2

Attaching the head strap

The head strap is fastened and adjusted using the hook-and-loop tape. Unfold both ends of the head strap
and proceed as follows:
Step 1
Take the shorter end of the head strap and slip it through the slot on the right of the virtual reality goggle (as
viewed in Figure 3-9). Ensure that the rougher side of the head strap is facing outwards. Continue to slip the
head strap through the left-hand side of the virtual reality goggle.
Figure 3-9 Attaching the head strap