Cramer 82TB10 Guia Del Usuario página 10

3
Insert the knob through the upper clamp.
EN
4 Tighten the knob.
Installing the battery pack
• Put the battery pack in the trimmer. Align the raised ribs on
battery pack with the grooves in the trimmer's battery port. Make
sure the battery pack is fully seated and secured in the trimmer
before beginning operation.
Removing the baterry pack
1 Push and hold the battery release button on the side of the rear housing.
2 Take out the battery pack and release the button.
Operation
WARNING!
Do not allow familiarity with products to make you careless.
Remember that a careless fraction of a second is sufficient to
inflict serious injury.
WARNING!
Always wear eye protection. Failure to do so could result in
objects being thrown into your eyes resulting in possible serious
injury.
WARNING!
Do not use any attachments or accessories not recommended
by the manufacturer of this product. The use of attachments or
accessories not recommended can result in serious personal
injury.
8
cramer.eu
(see Figure 4)
(see Figure 4)
Hold the product with the right hand on the trigger handle and the left hand on
the left handle. Keep a firm grip with both hands while in operation. Power head
should be held at a comfortable position with the rear handle about hip height.
Always operate power head at full throttle. If debris becomes wrapped around the
attachment, RELEASE THE SWITCH TRIGGER, and remove the debris.
Use the harness (only for 2100186, 2100386) when operation.
Starting/Stopping the trimmer
To start:
1 Press the on/off power button.
2 Pull the safety lock button back and meanwhile squeeze the switch trigger
to start.
3 Push the speed button forward to adjust speed depending upon grass
condition.
To stop:
1 Release the switch trigger.
2 Press the power button to turn the unit off.
Reverse function
•
If grass has winded up around the trimmer head or grass blade, simply
press the reverse button and do the two step operation for starting the
trimmer head again. The trimmer head will now reverse slowly for a shorter
period of time to help the user to come loose from the stuck situation.
4-Step speed limiter
•
4-step speed limiter function can be used to set the preferred rpm of the
trimmer head. This feature helps the user to hold the rpm at a suitable level
and by that saving run time. The limiter is adjusted by pushing the speed
button (6) forward one step at the time.
(see Figure 5)