Cramer 82TB10 Guia Del Usuario página 11

Ocultar thumbs Ver también para 82TB10:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 29
Maintenance
EN
Before each use, inspect the entire product for damaged, missing, or loose parts
such as screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and
do not operate this product until all missing or damaged parts are replaced.
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their
use. Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING!
Do not at any time let brake fluids, gasoline, petroleum-based
products, penetrating oils, etc., come in contact with plastic parts.
Chemicals can damage, weaken or destroy plastic which may
result in serious personal injury.
WARNING!
To avoid serious personal injury, always remove the battery pack
from the tool when cleaning or performing any maintenance.
Only the parts shown on the parts list are intended to be repaired or replaced by
the customer. All other parts should be replaced at an Authorised Service Centre.
Spool replacement (see Figure 8-9)
Use original manufacturer's replacement cutting line for best performance.
Remove the battery pack.
Push in tabs on both sides of the spool cover.
Remove the spool cover and the old spool.
To install the new spool, make sure the cutting line is captured in the
slot on the new spool. Make sure the end of the cutting line is extended
approximately 15cm beyond the slot.
Install the new spool so that the cutting line and the slot are aligned with
the eyelets in the cutting head. Thread the cutting line through the eyelets.
Pull the cutting line extending from the cutting head so the cutting line
10
cramer.eu
releases from the slot in the spool.
Reinstall the spool cover by depressing tabs into slots and pushing down
until spool cover clicks into place.
Cutting line replacement (see Figure 10)
Remove the battery pack.
Remove the spool from the cutting head.
NOTE: Remove any old cutting line remaining on the spool.
Cut a piece of cutting line approximately 3m long.
Bend the line at the midpoint and hook the loop into the slot in the center
rim of the spool. Ensure the line snaps into position in the slot.
Wind the line in the direction of the arrow shown on the bottom of the
spool. Once completed, put the line in the slots so it does not unwind.
Do not wind the line beyond the edge of the spool.
Assemble the brush cutter (see Figure 11)
WARNING!
Be careful of sharp edges and to wear gloves.
Remove the string head
Remove the battery pack.
Align the positioning hole on the fan blade with the hole on the
gear box. Insert a metal rod through the two holes.
Rotate the string head clockwise until it can be removed from the
gear shaft.
Assemble the brush cutter
Put the washer onto the center shaft.
Put the Brush-cutter Blade on top of the washer ensuring the

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

82tb162100186210038621012862101386

Tabla de contenido