Troubleshooting; Technical Data - Cramer 82TB10 Guia Del Usuario

Troubleshooting

EN
POSSIBLE
PROBLEM
CAUSE
String is
welded to
itself.
Not enough
string on
String will not
spool.
advance when using
String is
the bump-feed head.
worn too
short.
String is
tangled on
spool.
Grass wraps around Cutting tall
shaft housing and grass at
string head. ground level
Battery is
not secure.
Motor fails to start
when switch trigger
is depressed.
Battery is
not charged.
* If the fault is not solved, you must go to your distributor and/or nearest Authorized
Technical Service.
12
cramer.eu
SOLUTION
Replace string.
Install more string. Refer to string re-
placement earlier in this manual.
Pull string while pressing line release
button.
Remove string from spool and rewind.
Refer to string replacement earlier in this
manual.
Cut tall grass from the top down to
prevent wrapping.
To secure the battery pack, make sure
the latch on bottom of the battery pack
snaps into place.
Charge the battery pack according
to the instructions included with your
model.

Technical Data

PROPERTY
82TB10
Model
4 5 0 0 - 5 5 0 0 - 6 5 0 0 -
No load speed
7000 /min
Cutting head Bump feed
Cutting Line Diameter 2 mm
Cutting Path Diameter 40 cm
82V220G/82V430G/
Battery pack
82V220/82V430
Charger 82C1G/82C2/82C6
Weight (without battery pack) 4.5 kg
L
Measured sound pressure level
K
Measured sound power level L
Guaranteed sound power level 96 dB(A)
< 2.5 m/s
Vibration
k=1.5m/s
VALUE
VALUE
82TB16
4 5 0 0 - 5 5 0 0 - 6 5 0 0 -
7000 /min
Bump feed
2 mm
46 cm
82V220G/82V430G
82V220/82V430
82C1G/82C2/82C6
5.5 kg
＜ 96 dB(A), ＜ 96 dB(A),
L
PA PA
=3 dB(A) K =3 dB(A)
PA PA
＜ 93 dB(A) ＜ 93 dB(A)
L
WA WA
96 dB(A)
2 2
, < 2.5 m/s ,
2 2
k=1.5m/s