Novellini IRIS sx Manual De Instalación, Uso Y Mantenimiento página 36

Fill the disinfectant tank only on first use or when subsequen-
tly required, and press button 12 to release the system.
Then use button 13 to start the disinfection process.
The pump will activate and the disinfectant soon begins to
circulate. After 4 minutes, the pump stops for about 20 minu-
tes and then restarts for a further minute.
After this time, a symbol appears on the display to indicate
that the bath is ready to be emptied.
If the image below is displayed at the beginning of the di-
sinfection process, and disinfection does not start, adjust the
level of disinfectant.
Another reason for the disinfection process to fail to start may
be that there is insufficient water in the bath. In this case, the
image below will be displayed.
Top up the bath with water to restart the disinfection process.
Do not bathe in or use the water that has been used
for disinfection.
If the disinfection process is interrupted for any reason, the
disinfection symbol on the main menu lights up to warn that
disinfection has not been completed.
To cancel this warning, carry out a complete disinfection
cycle afresh.
Time adjustment menu:
From the main menu, press and hold the time button on the
display until the time adjustment sub-menu appears.
14 Press the + and - buttons to adjust the hours.
15 Press the + and - buttons to adjust the minutes.
16 Press to confirm and return to the main menu.
14
15
16
Alarm:
17 Communication failure between the central unit and the
remote control. Check that the power unit is switched on. If it
is not, contact the service centre.
17
02- Whirlpool Version with Airpool + Disinfection
Switching on:
Press the display and hold until the welcome screen appears.
Main commands:
1- Hydromassage
2- Disinfection
3- OFF (all active functions).
Hydromassage menu:
Press button 1 on the main menu to access the
hydromassage menu.
1
Select the hydromassage desired by repeatedly pressing the
relevant buttons 5 and 6.
Press button 7 to confirm and start the hydromassage.
36
To have the same hydromassage as last time, simply press
button 7 to start
the massage.
To change the duration of the massage, use the duration sub-
menu, which can be accessed by pressing button 4.
4
5 WHIRLPOOL
OFF
6 AIRPOOL
OFF
Hydromassage duration sub-menu:
The + and - buttons can be used to alter the duration of the
massage.
Once the desired time has been entered, press 8 to confirm.
Press 7 if you wish to start the massage.
The display shows the remaining hydromassage time; button
9 is lit to show that the massage is in progress.
9
NOTE: If the duration of the hydromassage is set to 0, the
massage will run for about 1 hour, starting from the last com-
mand entered.
If there is not enough water in the bath, the symbol 10 will
appear, at which point you will need to add water to start the
hydromassage automatically.
2
10
3
Whirlpool sub-menu:
Repeatedly press button 5 to select the Whirlpool function.
ENGLISH
5
6
7
MANUAL AUTOMATIC
CONTINUOUS TIMED
8