True RMS
Digital Multimeter
User Manual
5-7. Continuity Check
WARNING: To avoid electric shock, disconnect power to the unit under test
and discharge all capacitors before taking any resistance
_
measurements. Remove the batteries and unplug the line cords.
1 .Set the function switch to the green Cl CAP
-M-
•>))
position.
2. Press the
softkey labeled Mode.
Switch to
Conductace
3. Insert the black
test lead banana plug into the
negative COM jack. Insert the red test lead
banana plug into the positive jack.
4. If the resistance is less than approximately
25Q,
the audible signal will sound. If the circuit
is open, the display will indicate
"OL".
r
_
\
t
+
5-8. Diode Test
1 .Set the function switch
to the green
n
CAP
-M-
•»)
position.
2. Press the
softkey labeled Mode. Switch to
Diode.
3. Insert the black
test lead banana plug into the
negative COM jack and the red test lead banana
plug into the positive V jack.
4. Forward voltage will typically indicate 0.400
to
3.200V. Reverse voltage will indicate "OL".
Shorted devices will indicate
near
0V and
an
open device will indicate "OL" in both polarities.
\
-
\
+
H