KPC BK 500 S Manual De Instrucciones página 78

! If the fuse blows or if the overload protection is triggered, this is a sign that the machine is
overloaded and/or that too many appliances are connected to the same extension cable.
Check the cause and remedy. Do not install a more powerful fuse.
! Do not tug on the extension cable. Do not hold the cable taut. This can cause damage in
the plugs or in the cables insulation. Such damage is invisible but can be dangerous.
! Always keep the extension cable away from the machine. Disconnect the plug from the
electric socket and check the cable regularly for signs of damage or aging. Do not use the
machine with a damaged extension cable.
! If the cable is damaged, it must be replaced by an authorized service centre in order to
avoid a hazard.
! Never move the machine by pulling the cable. The machine must not be moved with the
motor running.
! The shredder must be assembled correctly before use.
! Warning! This appliance must be earthed!
! Warning! Use only three core extension cables with the earth wire connected.
! Only use extension cables that are approved for outdoor use and check that they are in
good condition before use.
! Before inserting the plug in the mains socket, make sure that the socket ratings are correct
and correspond to those indicated on the rating label on the shredder.
! Always switch off the shredder before disconnecting any plug and socket connector or
extension cables.
! Keep children and pets away. All onlookers should be kept a safe distance away from the
shredder when it is in use.
! Do not allow children or any person who has not read this instruction leaflet or who is not
familiar with the shredder to operate it.
! The operator is responsible for third parties while working with the shredder.
! Only use the shredder for its intended purposes.
! Caution! There are rotating blades on this machine.
! Caution! Blades do not stop immediately after switching off.
! Always switch off the shredder, disconnect the plug and wait until the cutting disc stops
before carrying out maintenance or cleaning work.
! It is forbidden to move or modify any of the electrical and mechanical safety devices.
! Use only in daylight or good artificial light.
! Do not put your hands into the feed funnel or ejection slot.
! If the shredder should start to vibrate abnormally, switch off the motor and check for the
cause immediately. Vibration is generally a warning of trouble.
! Ensure blades are secure before shredding. Do not operate the shredder if any of the
blades are not properly mounted.
! The shredder should be checked carefully before use. You should only work with a
shredder that is in good condition. If you notice any defect on the machine that may cause
danger to the operator, do not operate the shredder until defects are rectified.
! Replace worn or damaged parts for safety. Use only original spare parts. Parts not
produced by manufacturer may cause poor fit and possible injury.
! Use the shredder only in places where it is protected from water and never use it outdoors
in rainy weather.
! Store in a dry secure place out of reach of children,
! This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
! Children should be supervised to ensure that they do not play with the appliance.
P a g e | 5
EN