Maintenance And Storage; Additional Safety Instructions For Units With Bagging Attachments; Safety Warnings Gasoline - KPC BK 500 S Manual De Instrucciones

5.3

Maintenance and storage

! When the machine is stopped for servicing, inspection, or storage, or to change an
accessory, shut off the power source, disconnect the spark plug wire from the spark plug
(electric unit disconnect from supply), make sure that all moving parts have come to a
complete stop and, where a key is fitted remove. Allow the machine to cool before making
any inspections, adjustments, etc
! Store the machine where fuel vapor will not reach an open flame or spark. For extended
storage periods, run the unit dry of fuel. Allow the machine to cool before storing.
! When servicing the cutting means be aware that, even though the power source will not
start due to the interlock feature of the guard, the cutting means can still be moved by a
manual starting mechanism.
5.4

Additional safety instructions for units with bagging attachments

! Shut-off the power unit before attaching or removing the bag.

6 SAFETY WARNINGS GASOLINE

WARNING: Use extra care in handling fuels. They are flammable and the
vapours are explosive. The following points must be observed.
! Use only an approved container.
! Never remove the fuel cap or add fuel with the power source running. Allow engine exhaust
components to cool before refuelling.
! Do not smoke.
! Never refuel the machine indoors.
! Never store the machine or fuel containers inside, where is an open flame, such as a water
heater.
! If fuel is spilled, do not attempt to start the power source, but move the machine away from
the area of spillage before starting.
! Always replace and securely tighten the fuel cap after refuelling.
! If the tank is drained, this should be done outdoors.
P a g e | 7
EN