To Start Engine; Warm Engine Start; To Stop Engine - KPC BK 500 S Manual De Instrucciones

9.2

To start engine

Note: If engine fails to start after repeated attempts, refer to troubleshooting section.
Note: Always pull starter rope straight out. Pulling starter at an angle will cause rope to rub
against the eyelet. This friction will cause the rope to fray and wear more quickly. Always hold
starter handle when rope retracts. Never allow rope to snap back from extended position. This
could cause rope to snag or fray and also damage the starter assembly.
9.3

Warm engine start

! Move On/OFF switch to "ON" position.
! Pull the starter rope until the engine start up.
9.4

To stop engine

! Move ignition switch to the "STOP" position.
1. Move ON/OFF switch to "ON" position
2. Press the primer pump 2-3 times. Do not
press it exceed 5 times, otherwise, it will be
hard to start.
3. Pull the starter rope until the engine start up.
P a g e | 11
EN