Installing; Installing Of Outdoor Station (Camera); Installing Of Monitor - Extel WEVP 2200 E Instrucciones De Uso

4. INSTALLING

a. Installing of outdoor station, exterior camera
5
6
2
3
4
1
2
3
1. Remove the two screw covers (2) using a small screwdriver lodged in the notch (3) . Remove the two (4) screws.
2. Insert the plastic casing (1) taking care not to obstruct the plate fixation holes.
3. Connect the cable as shown in the wiring diagram with the waterproof gasket (6) in place.
4. Screw the plate onto the inserted casing using the two screws (4) .
5. Put the two screw covers back.
Make sure that the camera lens is not pointing directly at the sun or at a reflective surface.
Important !
Seal the upper joint between the exterior plate and the wall with silicone (5)
b. Installing of monitor
1. Put the wall carrier (2) in place.
2. Connect the wires coming
from the outdoor station.
3. Connect the adaptor plug (3)
to the back of the monitor (without
connecting it to the power supply).
4. Fix the monitor (1) to the wall
carrier (2).
5. Check that the installation iscomplete
and connect the adaptor to the
power supply.
N.B. : If the power supply cable is cut, check the polarity (black wire and black wire with grey edging)
CFI EXTEL WEVP 2200 E - 11/2011
GB5