Mobicool A40 Instrucciones De Uso página 12

Operating the cooler
I
NOTE
 Cool the cooler for about 24 hours before starting your journey
using gas or electricity from the mains. This way your cooler
will attain the required cooling capacity faster when you reach
your destination.
 The cooling capacity can be influenced by:
– The ambient temperature
– The amount of food to be conserved
– The frequency with which the lid is opened.
➤ Place the cooler on a firm and level base.
Check the horizontal position (±2°) with a spirit level if necessary.
➤ Open the lid of the control panel (fig. 2 1, page 3) by pressing down on it.
Press down on the lid again to close it.
I
NOTE
The further you turn the corresponding control towards "HIGH",
the lower the refrigerating temperature.
Connecting to 220 V – 240 Vw
!
WARNING!
Check that the voltage specification on the type plate corresponds
to that of the energy supply.
➤ Plug the earthed plug into a properly installed safety plug socket.
➤ Set the thermostat control (fig. 2 2, page 3) to "HIGH".
➤ Wait until the temperature in the cooler has dropped.
➤ Set the thermostat control (fig. 2 2, page 3) to the desired temperature
range.
➤ To switch off the cooler, set the thermostat control (fig. 2 2, page 3) to
"0" and pull out the plug.
12
A40
EN