Troubleshooting; Optional Accessories - Mafell ZS 260 E Manual De Instrucciones Y Lista De Piezas De Recambio

6

Troubleshooting

The determination of the causes of existing defects and their elimination always require
increased attention and caution. Pull out the mains plug beforehand!
Some of the most frequent defects and their causes are listed in the following chart. In case of other defects,
contact your dealer or the MAFELL customer service.
Defect
Machine cannot be switched on
Machine automatically switches off
while idling or stops while cutting
Saw chain jams as the machine is fed in Feed rate too fast
Drifting of saw chain or too much pres-
sure required as the machine is fed in
Chip ejection blocked
Saw chain runs on for too long after
switching off
7

Optional accessories

Guide rail, in one-part, complete 3 m (9.84 ft) long
Guide rail two-part, complete 3 m (9.84 ft) long
Guide rail extension, 1.5 m (4.92 ft) long
Pair of adapters for parallel guide fence to be attached to the guide rail
Flat file
Grease gun
Universal guide
h
Trolley ZS 260 E
Cause
No mains voltage
Mains fuse defective
Carbon brushes worn
Mains failure
Machine overloaded
Blunt saw blade
Bunt saw chain
Timber too damp
Automatic chain brake faulty
-23-
Elimination
Check power supply
Replace fuses
Take the machine to a MAFELL cus-
tomer service shop
Check mains back-up fuse
Reduce feed speed
Reduce feed speed
Release the switch immediately.
Remove the machine from the work-
piece and replace the chain or have
the chain resharpened in a MAFELL
customer service shop
Before resharping the chain make sure
that the minimum height is maintained -
see ill. 9
Replace the chain or have the chain
resharpened in a MAFELL customer
service shop
Take the machine to a MAFELL cus-
tomer service shop
Ref. No. 200 672
Ref. No. 037 037
Ref. No. 036 553
Ref. No. 037 195
Ref. No. 076 058
Ref. No. 076 158
Ref. No. 202 069
Ref. No. 202 113