Securing The Gear Motor; Unlocking For Manual Gate Movement - Vimar ELVOX EAM7 Manual Del Instalador

EAM7

6 - Securing the gear motor

Assembling the pillar bracket:
Securing the gearmotor to the pillar bracket:
- Unscrew the screw F, then remove the casing C.
- Insert the washer R putting it on the bracket .
- Insert the gearmotor.
- Lock the gearmotor with the screw V and nut (do not overtighten the
nut, check the rotation of the gearmotor that must have no friction).
V
R
Fastening the gate leaf drive bracket:
- Assemble the bracket as shown.
- Fit the gate leaf drive bracket to the pin of the gearmotor, locking it with
the screw V, placing washer R1 and R2 in between as shown in Figure
15. The smooth washer R1, has to be placed above the knurled washer
R2. It is recommended to lubricate the pin before inserting it into the
drive bracket.
F
C
R1
R2
V
Move the gate leaf into the fully closed position, check with a spirit level
that the gearmotor is in a perfectly horizontal position, then mark the two
points for drilling the gate leaf.
The fastening system must be chosen according to the material of which
the gate leaf is made.

7 - Unlocking for manual gate movement

Unlock the gearmotor by rotating the circular cover 180°, then insert the
release key and turn it 90°.
Now the gearmotor is unlocked and you can open and close the gate
leaf manually. Check with some complete movements that the fork runs
smoothly along its full travel.
Adjusting the mechanical limit stop:
In the bottom of the gearmotor there are two mechanical stops, one for
stopping the gate leaf on opening and one for closing. With the gate leaf
unlocked, move the gate leaf into the required open position, loosen the
mechanical stop A and take it to rest on the pin.
Move the gate leaf into the closed position, loosen the mechanical stop B
and take it to rest on the pin.
Check with some manual opening and closing movements that the gate
leaf stops at the correct point.
A
E N
45 mm
B
8