Troubleshooting; Maintenance - Delta MS250 Manual De Instrucciones

For assistance with your machine, visit our website at www.deltamachinery.com for a list of service centers or call the
DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).
CHANGING THE BLADE
Use only cross-cutting saw blades.
When using carbide-tipped blades, do not
use blades with deep gullets as they can
deflect and contact the guard.
Use only 10" diameter saw blades which are
rated for 5200 rpm or higher and have 5/8"
diameter arbor holes.
DISCONNECT MACHINE FROM POWER SOURCE!
1. Remove screw (A) Fig. 44 and rotate cover (B) to the rear
(Fig. 45).
2. To remove the saw blade, insert the hex wrench (C)
Fig. 46 into the hex hole located on the rear end of the
motor shaft to keep the shaft from turning.
3. Use a wrench (G) Fig. 47 to loosen the arbor screw (E) by
turning it clockwise.
4. Remove the arbor screw (E) Fig. 47, the outside blade
flange (F), and the saw blade from the saw arbor.
5. Attach the new saw blade making certain that the teeth
of the saw blade are pointing down (Fig. 47). Place the
outside blade flange (F) Fig. 45 on the arbor, and attach
the arbor screw (E) by turning it counter-clockwise using
the wrench (G) Fig. 45. At the same time, use the hex
wrench (C) Fig. 46 to keep the arbor from turning.
6. Rotate the cover back to the front and replace the screw
that was removed in STEP 1.
Remove wrenches (C) Fig. 46 and (G) Fig. 47
before starting machine.

TROUBLESHOOTING

MAINTENANCE

20
A
Fig. 44
Fig. 45
C
Fig. 46
E
B
Fig. 47
B
B
T
E
E
T
G
H