Maintenance; Cleaning - Hoshizaki AM-20CAE Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 52
ENGLISH
III. MAINTENANCE

1. CLEANING

Before carrying out any cleaning or maintenance operations, unplug the icemaker from the
electrical supply network.
This appliance must not be cleaned by use of a water jet.
When using a neutral cleaner or sodium hypochlorite, thoroughly read and understand the
instructions provided to prevent potential health problems.
It is recommended to ask a trained service person to clean and sanitise the icemaker water system.
Ask a trained service person to check and clean the condenser at least twice a year.
In areas where the water supply has a high mineral content, the spray jets may need frequent
cleaning. Increasing the harvest time will flush more water and help to reduce the frequency of
cleaning.
To prevent possible damage, do not clean the plastic parts with water above 40°C or in a
dishwasher.
Note: The wash switch on the front of the control box is intended for use by service
personnel only. During normal icemaking operation, keep the wash switch in the
"ICE" position.
[a] Machine and Bin Exterior
Wipe the exterior at least once per week with a clean, soft cloth. Use a damp cloth
containing a neutral cleaner to wipe off grease or dirt.
[b] Scoop and Storage Bin Handle Cleaning/Sanitisation (Daily)
1) Either mix 1 litre of water with 4 ml of 5.25% sodium hypochlorite solution in a suitable container, or the recommended
Hoshizaki sanitiser as directed.
2) Soak the scoop in the solution for more than 3 minutes. Rinse thoroughly, and shake to remove surplus liquid.
Note: Using a cloth to dry may re-contaminate.
3) Use a neutral cleaner to wash the storage bin handle. Rinse thoroughly.
4) Soak a clean cloth with the sanitising solution, and wipe the handle. Use fresh water and a clean cloth to rinse/dry.
[c] Storage Bin Interior Cleaning/Sanitisation (Weekly)
1) Open the storage bin door, and remove all ice.
2) Wash the bin liner with a neutral non-abrasive cleaner. Rinse thoroughly.
3) Soak a clean cloth with the neutral cleaner, and wipe both sides of the slope and the door inner surface. Wipe off the cleaner
with a clean damp cloth.
4) Either mix 5 litres of water with 18 ml of 5.25% sodium hypochlorite solution in a suitable container, or the recommended
Hoshizaki sanitiser as directed.
5) Soak a clean sponge or cloth with the solution, and wipe the bin liner, bin door and slope.
WARNING
CAUTION
NOTICE
8
Wash Switch

Publicidad

Tabla de contenido
loading

Tabla de contenido