Location; Installation - Hoshizaki AM-20CAE Manual De Instrucciones

ENGLISH
Remove shipping carton, tape(s) and packing. If packing material is left in the icemaker, it will
not work properly.
1) After removing the packaging, make sure that the icemaker is in good condition. If in doubt, please do not use the icemaker
and contact a professionally qualified person.
2) Remove the shipping tape holding the door and the separators inside the storage bin.
3) Remove the protective plastic film from the exterior. If the icemaker is exposed to the sun or to heat, remove the film after the
icemaker cools.
4) Remove the package containing the accessories. Check the contents according to "2. ACCESSORIES".

4. LOCATION

This icemaker is not intended for outdoor use.
The icemaker should not be located next to ovens, grills or other high heat producing
equipment.
This appliance is not suitable for installation in an area where a water jet could be used.
The location should provide a firm and level foundation for the icemaker.
Do not place anything on top of the icemaker or in front of the air vent.
The recommended operating ambient temperature is within 10°C to 35°C. But this icemaker is
capable of operating at 38°C. Water connection is cold water only. Operation of the icemaker,
for extended periods, outside of these normal temperature ranges may affect production
capacity.
This ice maker may be built into a work station or cabinet. There is no minimum clearance
requirement for the top or left and right of the machine.
Top View
In some high humidity environments, condensation may form inside the machine and drip onto
the floor. Do not install where the floor can be affected by water.

5. INSTALLATION

Incorrect installation can cause harm to people, animals or other items, for which the
manufacturer cannot be held responsible.
* Place the icemaker in the selected permanent location.
IMPORTANT
Rear
15cm
Left
ICEMAKER
Front
NOTICE
WARNING
CAUTION
NOTICE
Side View
Right Front
ICEMAKER
CAUTION
4
Top
Rear
15cm