Optimizing The Viewing Angle - Blackmagic Design SmartView Duo Manual De Instalación Y Funcionamiento

SmartView Duo and SmartScope Duo 4K
Tally Pin Connections
Pin Function
1 Monitor 1 Red
2 Monitor 1 Green
3 Monitor 1 Blue
4 Ground
5 Ground
6 Ground
7 Monitor 2 Red
8 Monitor 2 Green
9 Monitor 2 Blue

Optimizing the Viewing Angle

If SmartView Duo, SmartView HD or SmartScope monitors are to be installed high up in an
equipment rack, you may wish to physically invert the LCDs for the optimum viewing angle.
The images on the LCDs will automatically flip to the correct orientation when they sense an
inversion. A number 02 size pozidriv screwdriver is required to disconnect and reconnect the
faceplate from its rear assembly. This is a simple procedure and does not involve opening the
rear assembly.
The following procedure describes how to invert the unit while keeping the Blackmagic Design
logo in the correct orientation on the faceplate. A number 02 size pozidriv screwdriver
is required.
1 Remove the screws from the top, bottom, left and right sides of the
faceplate. SmartView Duo and SmartScope Duo 4K have 10 screws and
SmartView HD has 18 screws.
2 Lift the front faceplate away from the rear assembly as illustrated.
3 Invert the rear assembly.
4 Reinstate the faceplate on the inverted rear assembly.
5 Reinstate the screws in the chassis.
Your SmartView or SmartScope is now ready to be installed high up in a rack. Once bolted into
a rack, SmartView will continue to display the optimum viewing angle even if bumped, as there
are no external knobs or adjustments to mishandle or to come loose.
5 4 3 2 1
9 8 7 6
SmartView Tally-Port
SmartView HD and SmartView 4K
Tally Pin Connections
Pin Function
1 Red
2 Green
3 Blue
4 Ground
Optimizing the Viewing Angle 28