Cleaning And Maintenance; Troubleshooting - cecotec Mambo Manual De Instrucciones

ENGLISH

6. CLEANING AND MAINTENANCE

• Do not wash any of the appliance's parts in the dishwasher.
• Clean the food processor after each use.
• Unplug the appliance from the power supply and allow it cool down before cleaning it.
• Wash the removable cooking pot with warm soapy water. Rinse and dry thoroughly.
• Wipe the main body with a clean damp cloth. If food residue remains, dampen the cloth
in warm soapy water before wiping it. Never submerge the main body in water or other
liquid.
• In order to maintain the good performance of your appliance, check and clean the
removable bottom part of the jar after each use. Wipe it with a soft damp cloth and dry it
thoroughly before using it again.
• If the appliance is not going to be used for a long time, unplug it from the power supply
and store it in a cool and safe place.
Warning: Be careful when using the jar and do not in any circumstance put water in the inferior
area where the resistance is located.

7. TROUBLESHOOTING

Error code Description
E1 Safety switch
not fixed.
E2 Temperature
sensor error.
E3 The motor is
blocked.
E4 The tempera-
ture is too high.
E5 The motor's
temperature is
too high.
E6 The change in
speed could
not be done
successfully.
E7 y E8
32
Possible causes
The jar or the jar's lid is not fixed
properly.
The jar is not in its correct
position or connection of the
temperature sensor at the jar
base is damaged.
There is too much food inside
the jar.
There is no or very little food in
the jar and the set temperature is
too high for too much time.
The machine has been operating
with too much quantity of food
for too much time.
Speed change between low level
(1-5) and high level (6-10) was
blocked.
Solution
Re-assemble the jar and jar
lid, make sure all the parts are
assembled properly and tightly
and try operating it again.
Re-assemble the jar and make
sure it is fixed properly.
Remove some food from inside
the jar or cut the food to smaller
pieces and restart the machine.
Add food in the jar.
Stop operating the machine and
allow it to cool down before
restarting it again.
Remove the jar, turn the fixing
bracket manually and fix the jar
and restart.
Please, contact the Technical
Support Service of Cecotec at
+96 321 07 28.