Other Messages - SICE S 62 E Manual De Instrucciones

E 6 Error condition when executing optimisation programme.
Repeat the procedure from the beginning.
E 12 a) Mechanical width sensor not in the rest position when machine was switched
on. Switch off the machine, return the sensor to the correct position and switch
back on. If the error persists, call in the technical support centre.
b) External sensor not present or faulty. Visualisation of this error can be
disabled by performing the following procedure:
• press the
• use the
• press the
E 27 Excessive braking time. If the problem persists, contact the technical sup-
port centre.
E 28 Encoder counting error. If the error occurs frequently, call in the technical
support centre.
E 30 Wheel spin device failure. Switch off the machine and call in the technical
support centre.
E 32
The wheel balancer has been jolted during the reading phase. Repeat the
wheel spin.
E F0 Error in reading the 0 notch.
- This message indicates the valve of the wheel that must be brought to
OP.1
- This message indicates that the position of the valve must be moved
OP.2 180
- This message is displayed when the improvement obtained by optimi-
Out 2
- Press the
- Notice PREMATURE EXIT from the unbalance optimisation program.
Abo rt
- Press the
S 62 E Operator's manual
key
key.

19. OTHER MESSAGES

the 12 o'clock position during phases 1 and 5 of optimisation (OPt).
180° with respect to the previous position (12 o'clock).
sation is not sufficient.
key to exit the program or the
the optimisation phase.
key to confirm or the
programme.
keys to search for GAU CAL
key to continue
key to remain in the
119