SICE S 62 E Manual De Instrucciones página 120

Equilibradora de banco
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

- Notice TYRE MOUNTING INVERSION ON THE RIM in the OP.5 phase
--I- -I--
- This message indicates that the operator is in the "positioning the weights
HId dEn
no no
- This message is displayed if the wheel is balanced on the outer side.
- This message indicates that the machine is set for acquiring the P1 posi-
in -1-
- This message indicates that the machine is set for acquiring the P2 posi-
in -2-
- This message is displayed for approx. 3 seconds if the selected angle is
no -2-
- This message indicates the reference for acquiring the two points P1 and
in H.X
CAL GO
- Calibration spin.
- This message indicates the correct position for applying the calibration
I - -
CAL
- This message indicates the correct position for applying the calibration
-- I
CAL
End CAL
- This message indicates the end of the unbalance calibration programme.
GO
ALU
- Spin with ALU programme selected.
GO
d15
- Spin with Motorcycle Dynamic programme selected.
GO
A15
- Spin with Motorcycle ALU programme selected.
- Spin with Static programme selected (car/motorcycle environment) or
St
- This message indicates the selection of the Static balancing programme
St
biE
- This message indicates the selection of the dynamic balancing programme
dyn
biE
120
of the programme.
If you do not want to (or cannot) carry out this operation, press the
key. the machine will provide the instructions to complete
the programme without inversion.
behind the spokes Hidden Weight" programme.
tion behind the first spoke
tion behind the second spoke.
greater than 120 degrees, indicating that the procedure must be repeated
correctly.
P2 behind the spokes. Depending on the configuration performed by
the operator, the message on the display can be H3, H6 or H12. If the
laser indicator is enabled, the reference will be 6 o'clock (H.6).
weight in the unbalance calibration programme at the end of the first
spin.
weight in the unbalance calibration programme at the end of the second
spin.
when the Static balancing programme is selected in the vehicle working
environment.
in the motorcycle working environment.
in the motorcycle working environment.
S 62 E Operator's manual

Publicidad

Tabla de contenido
loading

Tabla de contenido