Check For Correct Functioning Of Balancing Accessories; Troubleshooting - SICE S 62 E Manual De Instrucciones

- This message indicates the selection of the ALU balancing programme
ALU biE
ccc ccc
- Unbalance values greater than 999 grams.
- This message indicates the Inner Plane for applying the adhesive weight
--- A-1
in the ALU1P balancing programme
- This message indicates the External Plane for applying the adhesive
A-2 ---
weight in the ALU1P/ALU2P balancing programme
CHECK FOR CORRECT FUNCTIONING OF
BALANCING ACCESSORIES
Checking balancing accessories allows the operator to make sure that wear has not al-
tered the mechanical specifications of flanges, cones, etc. beyond the specified limits.
A perfectly balanced wheel, which has been disassembled and reassembled in a different
position, should not show an unbalance value greater than 10 grams.
When a higher unbalance is found, check all the accessories carefully and replace the
components that are not in perfect condition (e.g. showing dents, abnormal wear, flange
unbalance, etc.).
Anyhow it is necessary to bear in mind that, if the cone is used to centre the wheel,
satisfactory balancing results cannot be achieved if the central hole of the wheel is out-
of-round or incorrectly centred; Better results can be achieved by centring the wheel
using the securing holes.
Bear in mind that any re-centring error made when the wheel is mounted on the car can
be removed only removed with an "on-the-vehicle balancing" of the wheel, using an on-
the-vehicle wheel balancer to complement the work of the wheel balancer.
Below is a list of faults that may occur and that the user can solve if the cause is found
among those indicated.
For any other malfunction or fault call in the technical support centre.
No power at the socket.
Check the mains voltage is present.
➥
Check the electrical power circuit in the workshop.
➥
The machine plug is defective.
Check that the plug is undamaged.
➥
One of the FU1-FU2 fuses of the rear electrical panel has blown
Replace the blown fuse.
➥
S 62 E Operator's manual
in the motorcycle working environment.

TROUBLESHOOTING

The machine does not switch on
(the displays remain switched off)
121