Technical Problems; Storage; Environmental Protection; Warranty - Narex EPR 35-23 Instrucciones De Uso Originales

English

Technical problems

‰ Engine is not started: Check the power supply source (socket).
Check the lead-in cable for possible damage. If remedy is not
reached, handover the chainsaw to the specialized workshop or to
the manufacturer's service centre.
‰ Chain is not started: Check position of the hand guard (4). The
chain is started at the released brake only.
‰ Heavy engine sparkling: Damaged engine or carbon brush.
Handover the chainsaw to the specialized workshop or to the man-
ufacturer's service centre.
‰ Oil is not distributed: Check oil level. Clean holes in the bar for
smooth oil fl ow (see also corresponding instruction in the part
"Maintenance and cleaning"). If remedy is not reached, handover
the chainsaw to the specialized workshop or to the manufacturer's
service centre.
Attention! The maintenance and repair works other than
those contained in this Operating Manual may be per-
formed by authorized staff or by the manufacturer's ser-
vice centre only.
Attention! Damaged lead-in cable of the chainsaw may be
replaced only by the specialized workshop authorized by
the manufacturer or by the manufacturer's service centre,
because special tools are necessary for this operation.

Storage

Packed appliance may be stored in dry, unheated storage place with
temperature not lower than -5 °C.
Unpacked appliance should be stored only in dry storage place with
temperature not lower than +5 °C with exclusion of all sudden temper-
ature changes.

Environmental protection

Power tools, accessories and packaging should be sorted for environ-
mental-friendly recy.
Only for EU countries:
Do not dispose of power tools into household waste!
According to the European Directive 2002/96/EC on waste electrical and
electronic equipment and its incorporation into national law, power
tools that are no longer suitable for must be separately collected and
sent for recovery in an environmental-friendly manner.

Warranty

Our equipment is under warranty for at least 12 months with regard to
material or production faults in accordance with national legislation. In
the EU countries, the warranty period for exclusively private use is 24
months (an invoice or delivery note is required as proof of purchase).
Damage resulting from, in particular, normal wear and tear, overloading,
improper handling, or caused by the user or other damage caused by
not following the operating instructions, or any fault acknowledged at
the time of purchase, is not covered by the warranty.
Complaints will only be acknowledged if the equipment has not been
dismantled before being sent back to the suppliers or to an authorised
NAREX customer support workshop. Store the operating instructions,
safety notes, spare parts list and proof of purchase in a safe place. In
addition, the manufacturer's current warranty conditions apply.
Note
Due to continuous research and development work, we reserve the
right to make changes to the technical content of this documentation.
24
EC Certifi cate of Conformity
We declare that this device meets requirements of the following stand-
ards and regulations.
Safety:
EN 60745-1; EN 60745-2-13
Directive 2006/42/EC; Directive 2000/14/EC
Electromagnetic compatibility:
EN 55014-1; EN 55014-2; EN 61000-3-2;
EN 61000-3-11
Directive 2004/108/EC
RoHS:
Directive 2011/65/EU
Method of assessment of conformity:
Article 12 of Directive 2006/42/EC
Certifi cado de examen de tipo: MGA1706, TŰVSŰD No. 123
Place of storage of the technical documentation:
Narex s.r.o., Chelčického 1932, 470 01 Česká Lípa, Czech Republic
2019
Narex s.r.o.
Chelčického 1932
470 01 Česká Lípa
Maciej Stajkowski
CEO of the company
April 1, 2019