Publicidad
Idiomas disponibles
Idiomas disponibles
Pullout Freezer Drawer
(select
models)
Materials
Needed:
• Phillips screwdriver
To Remove:
1. Pull drawer open to full extension.
2. Tilt the lower basket
forward and lift to remove.
3. On each white drawer
bracket is a basket cradle
with two snap attachments.
To release each cradle,
unlatch the snaps by
pushing them inward,
away from the side
bracket. Lift the cradles
off of the rails.
/4. Remove Phillips screw
from each of the drawer
slides (select models).
5. Lift top of drawer front
to unhook the drawer
from the slides. Lift
door front out to
remove.
To Install:
1. Pull both rails out to
full extension.
2. While supporting
door front, hook
supports
into slots
located on inside of
each slide.
Note:
All four drawer bracket supports
must be in
the proper slots for the drawer to function
properly.
.
/4.
.
Lower door front into final position.
Replace and tighten Phillips screws that were
removed from the drawer slides (select models).
Place the basket cradles back onto the drawer
slides. Align basket cradle snaps with the slots on
the drawer brackets and press each cradle toward
the bracket until it clicks.
Basket cradle
6. Tilt the lower basket front down and set it down
into the basket cradles.
I
Publicidad
