Installation On The Tyre Changer - Corghi SP 2300 Manual De Uso

the machine and consult it whenever you are
in need of confirmation or explanations.
WARNING
Do not remove or deface the safety Danger,
Warning or Instruction decals. Replace any
missing or illegible decals. Missing or damaged
decals can be obtained at your nearest dealer.
- When using and carrying out maintenance on
the machine observe the unified industrial
accident prevention regulations for high voltage
industrial equipment.
- Any unauthorised alterations made to the
machine automatically release the manufac-
turer from any liability in the case of damage
or accidents attributable to such alterations.
Specifically, tampering with or removing the
machine's safety devices is a breach of the
regulations for industrial accident prevention.
WARNING
When operating or servicing do not wear ties,
loose fitting clothes, necklaces, rings or wri-
stwatches that could become entrapped by
moving parts.
INSTALLATION ON
THE TYRE CHANGER
• Disconnect the machine from the mains fig.1
and compressed air line fig. 2.
• Disconnect the air hoses T of the filter-
regulator unit on the rear right of the casing
and remove the unit fig. 2 and the grease
cone support
26
• Remove the side cover fig. 3;
• Remove the guard from the base of the
column, fig. 3;
• Install the column on the tyre changer
• Fix it to the tyre changer with the screws
supplied in the kit, in the points indicated in
the figure. 4)
• Install the power unit on the column, securing
it with the screws supplied in the points
indicated in fig. 5:
1. Insert the screw E, nut and washer G;
1
2. Insert the column F and then put the screw
A back in place (do not put the washer B
back, removed earlier);
3. Mount the bracket H fig. 5 on the side bead
breaker beam with the screws I, the block L
and the nuts M
SP 2300 - Operator's manual + spare parts
T
V
2
3