Tyre Demounting/Mounting - Corghi SP 2300 Manual De Uso

USE
TYRE DEMOUNTING/
MOUNTING
WARNING
For all tyre mounting/demounting procedures
not specifically described, refer to the tyre
changer use and maintenance manual.
HELP is designed to facilitate the demounting
and mounting stages of the light alloy rims and
particularly stiff low-profile tyres.
Proceed as follows to get the best performance
from these accessories. Proceed with bead
breaking the tyre as described in the instruction
manual enclosed with the tyre changer.
Demounting
SP 2300 - Operator's manual + spare parts
- After breaking the bead of the wheel place it
on the turntable and clamp it on the outside.
- Fit the rim clamping cone on the end of the
articulated arms, align the cone with the hole
in the centre of the rim and press the down
lever (fig.11) until the sliding clamps are
inserted between the rim and tyre (fig.12),
then press the pedal to clamp the wheel.
- Remove the centring cone, put it away and
remount the bead presser block.
- Tilt the column forwards and position the
mounting/demounting tool.
- Align the rim clamping roller tangent to
the outside diameter of the rim, press the
descent lever (fig. 13) until there is enough
room between the mounting/demounting tool
and the tyre in which to insert the bead lifter
lever (fig. 14).
11
12
13
WDK
31
UK