Frame Dust Filter Cleaning And Integrity Check; Pocket Dust Filter Cleaning And Integrity Check - Nilfisk-Advance Terra 5200B Instrucciones De Uso

FRAME DUST FILTER CLEANING AND
INTEGRITY CHECK
NOTE
Besides the standard paper filter, optional
polyester filters are also available. The
following procedure is applicable to each
type.
1. Drive the machine on a level ground and engage the
parking brake by means of the pedal and the lever (26
and 19, Fig. B).
2. Turn the ignition switch (18, Fig. B) to "0" position.
3. Open the hood (13, Fig. C) and hold it by using the
related rod (16, Fig V).
4. Disconnect the battery connector (4, Fig. V).
Remove the filter cover (2, Fig. M) by disengaging it
from the retainers (1).
5. Disconnect the electric connector (1, Fig. N) from the
filter shaker.
6. Remove the filter shaker support frame fixing knobs
(2, Fig. N).
7. Remove the filter support frame (3, Fig. N).
8. Pull out the dust filter (4, Fig. N).
9. In an appropriate outdoor area, clean the filter
shaking it on a level and clean surface, tapping the
side (1, Fig. O), opposite the wire gauze (2).
Complete the cleaning by using compressed air (3) at
max. 6 bars, blowing only from the side protected by
the wire gauze (2), at a minimum distance of 30 cm.
According to the filter type, take care of the following
cautions:
– Paper filter (standard): do not use water or
detergents to clean it; the filter can be damaged;
– Polyester filter (optional): to clean it, see the
above-mentioned instructions. If necessary, for a
better cleaning, it is allowed to wash the filter with
water and non-lathering detergents. This provides
better quality cleaning but reduces the life of the
filter, which will have to be replaced more
frequently. The use of inadequate detergents can
damage the filter.
Check the filter body for lacerations.
10. Clean the filter compartment rubber seal (1, Fig. P)
along its perimeter and check its integrity. If
necessary, replace it.
11. Install in the reverse order of removal (steps from 8 to
1).
WARNING!
When reinstalling the filter, the wire gauze
(2, Fig. O) must be facing upward.
146 1996 000(2)2004-08 – Terra™ 5200B
INSTRUCTIONS FOR USE
POCKET DUST FILTER CLEANING AND
INTEGRITY CHECK
NOTE
The polyester pocket filters are normally
kept clean by activating the electric filter
shaker supplied with the machine.
If necessary, they can be cleaned using the
procedure indicated below.
When the filtration surfaces are no longer
suitable, the filter must be replaced.
1. Drive the machine on a level ground and engage the
parking brake by means of the pedal and the lever (26
and 19, Fig. B).
2. Turn the ignition switch (18, Fig. B) to "0" position.
3. Open the hood (13, Fig. C) and hold it by using the
related rod (16, Fig. V).
4. Remove the filter cover (2, Fig. M) by disengaging it
from the retainers (1).
5. Unscrew the knobs (1, Fig. AA) and remove the
brackets (2).
6. Pull out the dust filter (1, Fig. AB), and remove it after
disconnecting the electrical connector (2) from the
filter shaker.
7. Disassemble the polyester filtering surface, as
indicated by the following steps; these procedures
must be carried out in a suitable outdoor area and the
Operator must be suitably equipped (gloves, mask,
glasses).
8. Remove the filter shaker motor (1, Fig. AC) by
unscrewing the two fixing screws.
9. Open the filter shaker motor support unit (2, Fig. AC)
completely and release the filtering pocket tension
rods (3).
10. Remove all the filtering pocket tension rods (4, Fig.
AC).
11. Open the upper retaining cord (5, Fig. AC) of the
closed pocket filter to remove it from the upper frame
(6).
12. Remove the internal pocket separator (7, Fig. AC).
13. Clean the polyester fibre surface (8, Fig. AC) from the
dirty side, using an external vacuum cleaner,
spreading it out completely or cleaning pocket by
pocket. At the same time, clean both the surfaces of
the pocket separator (7, Fig. AC) removing anything
deposited on them. Check that the filtering surface is
not cut, if it is, replace it. It is also possible to use
compressed air (max. 6 bars), blowing the air from
the clean side towards the dirty side.
WARNING!
It is not advisable to wash the filter with
water. The polyester fibre can shrink and
become unusable.
13