Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
GB
2
Safety information
2.1
Possible hazards
Burn hazard!
The nozzle (1) and melted glue can reach temperatures of over 200 °C
(392 °F). Always wear heat protecting gloves when working with the
device.
Irritating smells!
Hot melt adhesives give off vapors which can have irritating smells.
Ensure that there is sufficient ventilation.
If the device is improperly used, isolated instances of mucous
membrane irritation could occur. You should contact a doctor
immediately in such cases!
2.2
Information for safe operation
In order to protect against malfunctions and maloperation, always follow the
following information exactly:
• Remove combustible or heat-sensitive objects from the vicinity of the
nozzle (1).
• The warmed-up device must be placed on its stand (2). It must never be
placed on its side.
• Never operate the trigger (3) with excessive force.
• Protect the device from moisture and wetness (electric shock protection).
• Observe the information contained in the hot melt adhesive processing
sheet (processing error avoidance).
• If working above head height, ensure that drops do not form to protect
against burns to personnel or working equipment.
• Always remove the power cable before carrying out any work to the device
(maintenance, cleaning)
• The device may only be operated on sockets with a protective earth.
• Any extension cables must also be provided with a protective earth. Check
that the extension cable is in good condition before use.
• Always remove the mains plug after use. Allow the device to cool down
completely before storing it.
• If you observe damage to the device or the power cable, remove the mains
plug immediately. Ensure that the device is checked immediately by an
electrician. It may only be put into operation once again after repairs have
been correctly carried out (see chapter 5).
Safety information
11
Publicidad
Tabla de contenido
