Resetting The Adjustments; Technical Features; Damper Wires; Plug & Play - IBM P260 Manual De Instrucciones

Customizing Your Monitor

Resetting the Adjustments

Resetting an adjustment item
1
Press the and . /> buttons to select the OSD
containing the item you want to reset, and press the
button again.
2
Press the . /> buttons to select the item you want to
reset.
3
Press the ? (reset) button.
Resetting all of the adjustment data for
the current input signal
When there is no OSD displayed, press the ? (reset)
button.
All of the adjustment data for the current input signal is
reset to the factory settings.
Note that the following items are not reset to the factory
settings.
OSD language
•
adjustment mode in the COLOR OSD (EASY, EXPERT,
•
sRGB)
OSD position
•
control lock function
•
Resetting all of the adjustment data for all
input signals
Press and hold the ? (reset) button for more than two
seconds.
All of the adjustment data, including the brightness and
contrast, is reset to the factory settings.
Note
The ? (reset) button does not function when
LOCK) is set to ON.

Technical Features

Damper Wires

When viewing a white background, very thin horizontal
lines may be visible on the screen as shown below. These
lines are the shadows of the damper wires and are
characteristic of CRTs that use aperture grilles. The wires
are attached to the aperture grille on the inside of the
Trinitron tube and prevent the vibration of the aperture
grille.
Plug & Play
This monitor complies with the DDC1, DDC2B and DDC2Bi
Display Data Channel (DDC) standards of VESA.
When a DDC1 host system is connected, the monitor
synchronizes with the V. CLK in accordance with the VESA
standards and outputs the EDID (Extended Display
Identification Data) to the data line.
When a DDC2B or DDC2Bi host system is connected, the
monitor automatically switches to the appropriate standard.
(CONTROL
Customizing Your Monitor
Damper wires
EN
15