Additional Information; Warning Messages; Technical Features - IBM P260 Manual De Instrucciones

Additional Information

Warning Messages

If no pictures appears on the screen, one of the following
messages appears on the screen.
If NO INPUT SIGNAL appears on the screen
I NFORMA T I ON
MON I TOR I S WORK I NG
I NPUT 1 :
NO I NPUT
ACT I VA T E US I NG PC
CHECK I NPUT SE L ECT R
CHECK S I GNA L CAB L E
WH I T E
RED
GREEN
B L UE
1 The selected connector
This message shows the currently selected connector
(INPUT 1 or INPUT 2).
2 The input signal condition
NO INPUT SINGAL
This indicates that no signal is input, or that no signal is
input from the selected connector.
3 The remedies
One or more of the following messages may appear on
the screen.
• If ACTIVATE USING PC appears on the screen, try
pressing any key on the computer, and confirm that
your computer's graphic board is completely seated
in the correct bus slot.
• If CHECK INPUT SELECTOR appears on the screen,
try changing the input signal (page 5).
• If CHECK SIGNAL CABLE appears on the screen,
check that the monitor is correctly connected to the
computer (page 4).
S I GNA L
O
If OUT OF SCAN RANGE appears on the screen
I NFORMA T I ON
MON I TOR I S WORK I NG
I NPUT 1 : 1 3 0 . 0 k H z /
OUT OF SCAN RANGE
CHANGE S I GNA L T I M I NG
WH I T E
RED
GREEN
B L UE
1 The selected connector and the
frequencies of the current input signal
This message shows the currently selected connector
(INPUT 1 or INPUT 2). If the monitor recognizes the
frequencies of the current input signal, the horizontal
and vertical frequencies are also displayed.
2 The input signal condition
OUT OF SCAN RANGE
This indicates that the input signal is not supported by
the monitor's specifications.
3 The remedies
CHANGE SIGNAL TIMING appears on the screen. If
you are replacing an old monitor with this monitor,
reconnect the old monitor. Then adjust the computer's
graphic board to that the horizontal frequency is
between 30 - 121 kHz, and the vertical frequency is
between 48 - 160 Hz.
For more information, see "Troubleshooting" on page 18.

Technical Features

7 5 H z
17
EN