Setting The Dimension; Determining And Setting The Distance Value (A); Determining And Adjusting The Nominal Size (B); Determining And Adjusting The Nominal Diameter (D) - Zipper Maschinen ZI-RWM99 Manual De Instrucciones

17.2 Setting the dimension

17.2.1 Determining and setting the distance value (a)

Reading point
Ablesepunkte:
a

17.2.2 Determining and adjusting the nominal size (b)

Set the nominal size (b). It usually can be found on the rim. If necessary, use the grab
compass, to determine the nominal diameter (b) by placing the heads of the grab compass on
the left and right side of the rim and reading the value from the scale on the grab compass
(see diagram above).
The value is entered by pressing the M
corresponding arrow keys.
The increment of the scale is 5 millimeters or for inch input 0.25 Inches. The following values
are shown in the display (for inch-setting only):
.2 for ¼ inches;. 5 for ½ inches and . 7 for ¾ inches

17.2.3 Determining and adjusting the nominal diameter (d)

The nominal diameter is indicated on the tyres. Enter the value by pressing the M
D (d) key on the control panel using the corresponding arrow keys.
IAMETER
ZIPPER MASCHINEN GmbH
ZI-RWM99
www.Zipper-Maschinen.at
1. Pull out the special gauge to the inner
rim edge
(The increment of the scale is 0.5 cm,
the full range is reached at 18 cm.)
2. Read the distance value from the scale.
3. Set the value a using the
corresponding arrow keys on the
control panel (M
(a)) to the desired value.
I W key (b) on the control panel using the
ANUAL NPUT IDTH
OPERATION
I D
ANUAL NPUT ISTANCE
I
ANUAL NPUT
28