FujiFilm INSTAX SHARE SP-3 Manual De Instrucciones página 10

Connecting and Printing (Continued)
⁄
EN
@
10
instax_BO-C_6lang.indb 10 instax_BO-C_6lang.indb 10
Tap "Connect and print".
Before tapping "Connect
and print", tapping on
the lower right displays the
edit menu. You can add
a template or adjust an
image on this menu.
Tap "Done" to exit from the
menu.
When a printer is detected,
tap "Connect". If multiple
printers are detected, select
the printer to connect from
the list.
Printer's identifier (SSID) is
located on the bottom of the
printer.
¤
Enter the factory default
password (1111) or the one you
specified, then tap "OK".
The printer starts printing.
When printing, put the
printer on a steady surface
such as a desk.
To reset the password to the factory default
(1111), turn the printer on while holding the
REPRINT button.
#
When the film has been ejected (the
printer stops making a sound), grasp
the edge of the film, then take it out.
1 remaining film LED turns off every
time you print an image.
2017/9/14 15:21:11 2017/9/14 15:21:11