FujiFilm INSTAX SHARE SP-3 Manual De Instrucciones página 17

Problems
The film pack cannot
be loaded, or cannot be
loaded smoothly.
The film cover cannot
be ejected.
The film cannot be
ejected to the end.
The film pack cannot be
ejected.
instax_BO-C_6lang.indb 17 instax_BO-C_6lang.indb 17
Possible Causes
1 The film pack is not for your printer.
2 The film pack is not being loaded
correctly.
● The printer cannot recognize the
film pack.
● The printer shakes or has been
dropped and the film has become
misaligned.
1 The printer shakes or has been
dropped and the film is misaligned.
2 The film has been jammed.
Solutions
1 Use FUJIFILM Instant Film "instax SQUARE" only.
(No other films can be used.)
2 Match the yellow line on the film pack with the
yellow positioning mark in your printer.
● Remove the film pack and load it again.
1 Grasp the edge of the film and pull it out.
2 Performing another printing operation pushes
the jammed film out.
1 Load a new film pack.
2 Remove the battery and insert it again. If this does
not solve the problem, remove the jammed film
and load a new film pack.
EN
17
2017/9/14 15:21:13 2017/9/14 15:21:13